First Configuration and Startup of the Sinamics V20 VFD
You reset a SINAMICS V20 to factory settings, enter the motor data from the rating plate and run the motor for the first time from the operator panel. You also set up the first connection macro.
Sinamics V20 Control with Digital and Analog Signals from the S7-1200 G2
You wire the SINAMICS V20 to an S7-1200 G2 PLC and configure analog signals in TIA Portal. Then you control start, stop, direction and speed from the PLC.
Sinamics V20 Control over the USS Protocol from the S7-1200
You wire the USS bus, set the drive communication parameters and program USS communication in TIA Portal. Then you test start, stop, speed setpoint and status readout.
Sinamics V20 Control over Modbus RTU from the S7-1200
You wire Modbus RTU, set the drive parameters and read the register map. Then you program the communication blocks in TIA Portal and test control of the drive.
Configuration and Startup of the Sinamics G120 in Startdrive
You install Startdrive, add a SINAMICS G120 to a TIA Portal project and go through the commissioning wizard. Then you start the motor in commissioning mode and control the drive from the PLC with SINA_SPEED and Telegram 1.